|
|
|
|
|
HEIM JOINT SAFETY WASHER, 3/4
|
|
SAFETY WASHER, 3/4 sold each Supplied by Latest Rage
Safety washers were designed to prevent the rod end from going over a twelve point or allen bolt head if the heim joint fails. There is a slight tapered profile that will allow the heim joint to rotate without hitting the edge of the safety washer.
|
|
|
|
|
|
|
|
7/8" To 3/4" Stainless High Misalignment Spacers 2" Height
|
|
(SOLD EACH)
7/8 TO 3/4
2" STACKED HEIGHT IN HEIM
SUPPLIED BY RUFFSTUFF SPECIALTIES
|
|
|
|
|
|
|
|
7/8" MISALIGNMENTS STAINLESS 5/8" BOLT 2 1/16 STACKED HEIGHT
|
|
STAINLESS MISALIGNMENT SPACERS For use with 7/8" bore heims or uniballs and 5/8" bolt 5/8" stand off
These make your stacked height in heim 2 1/16
price is for one piece
|
|
|
|
|
|
|
|
7/8" MISALIGNMENTS STAINLESS 9/16" BOLT
|
|
STAINLESS MISALIGNMENT SPACERS For use with 7/8" bore heims or uniballs and 9/16" bolt 1/2" off set STAINLESS
price is for one piece
|
|
|
|
|
|
|
|
7/8" To 5/8" Stainless High Misalignment Spacers 2" Height
|
|
(SOLD EACH)
7/8 TO 5/8
2" STACKED HEIGHT IN HEIM
SUPPLIED BY RUFFSTUFF SPECIALTIES
|
|
|
|
|
|
|
|
7/8" To 3/4" Saftey Stainless Misalignment 2" Height
|
|
(SOLD EACH)
7/8 TO 3/4 SAFETY WASHER MISALIGNMENT
2" STACKED HEIGHT IN HEIM
1.600 WIDTH OF HEAD
Not Safety Washers & not Standard High Misalignment. I was looking to add Safety Washers to our line up but something kept bugging me. Wouldn’t the mating surface between the High Misalignment and the Safety Washer add more stress to something you are trying to make more safe? Misalignment goes inside the bore of the rod end to remove the stress but a traditional Safety Washer goes on top of the stack and adds an unresolved join right next to the bolt end.
SUPPLIED BY RUFFSTUFF SPECIALTIES
|
|
|
|
|
|
|
|
7/8" MISALIGNMENTS STAINLESS 1/2" BOLT 2 1/8 STACKED HEIGHT
|
|
STAINLESS MISALIGNMENT SPACERS For use with 7/8" bore heims or uniballs and 1/2" bolt FITS JMX14T-770
These make your stacked height in heim 2 1/8
price is for one piece
|
|
|